Gas springs for spring-piston air rifles and pistols
High pressure gas spring (hereinafter referred to as HP). It is pumped with nitrogen (N) at the most optimal pressure for the corresponding model of a spring-piston air rifle. All AirMagnum gas springs are equipped with a pressure control (bleed) assembly. The GP will allow you to carry the rifle in the cocked state for a long time without any deterioration in performance characteristics (tactical and technical characteristics), will reduce recoil, shot noise, increase the rifle's resource by 5 times and improve accuracy when firing. Under optimal operating conditions, the resource is up to 8-10 yew. shots without refueling, and the total resource reaches 30,000 shots. The advantage of gas springs in comparison with conventional metal springs is that their stiffness coefficient does not change over time, which means greater stability of the rifle's characteristics due to the absence of spring shrinkage. All our GPs are tested and pressurized for overpressure, which means that you get a reliable, proven high quality product that will not let you down in any weather from -20 to +40 * C. The GP uses special lubricants that work optimally under extreme conditions.
When ordering a gas spring, you can specify the power option:
- weakened (optimal use of bullets 0.4gr. - 0.55gr or order with a mark for a bullet range of 0.28gr.),
- standard (close to the native coil spring or slightly higher, optimal for bullets from 0.57 g. to 0.72 g),
- reinforced (optimal use of bullets 0.75 g and above),
- your version (you can specify what pressure you need inside the GP cylinder from 5 atm. to 250 atm., we recommend no more than 170 atm. for supermagnums, even less for magnums).
If you have not found a gas spring for your model of an air rifle or pistol on our website, please note that we have more than 300 gas. springs and cannot determine which model you have, then call us back and together we will determine which gas spring you need.
If, nevertheless, you come across a rare model of a spring-piston air rifle or pistol, and this happens, especially old models, you should know that we can make a GP according to the internal dimensions of your model within 1-2 work. days.
You can also take measurements of the internal dimensions of an air rifle or pistol, for this you need to go to the product card Removing dimensions and order a GP: https://airmagnum.com.ua/snyatie-razmerov. Or entrust it to our qualified specialists who have more than 11 years of experience in working with airguns.
Our company can produce a gas spring for any spring-piston air rifle or piston with a side engagement of the piston. The GP is not installed on pneumatic weapons with a central piston engagement, and if they want to sell you a GP for this model, know that you are being deceived and bypass such shops.